Sandwich panel designed and manufactured especially for industrial or residential decks, that is, we can cover from a garage to a large logistics center, we adapt to their needs at all times.
When the roof only has a fall, the roof sandwich panel must be left tight against the facade or wall on which it rests to avoid water seepage. The rear apron is the closing closing of the roof against the facade.
The rear apron may be stamped or uncut at the customer’s choice.
This panel can say that is the most established in the market model, because its design with a flashing at the junction of each panel, leaving the screws covered with the same, is the most widely accepted by our customers.
The particularity of these panels is that on the inside of the panel, replace the plate by a polyester film which gives it durability.